DEPARTMENT OF LICENSING AND REGULATORY AFFAIRS
DIRECTOR'S OFFICE
CONSTRUCTION SAFETY AND HEALTH STANDARD
(By authority conferred on the director of the department of licensing and regulatory
affairs by sections 14, 16, 19, 21, and 24 of the Michigan occupational safety and health act,
1974 PA 154, MCL 408.1014, 408.1016, 408.1019, 408.1021, and 408.1024, and Executive
Reorganization Order Nos. 1996-1, 1996-2, 2003-1, 2008-4, and 2011-4, MCL 330.3101,
445.2001, 445.2011, 445.2025, and 445.2030)
PART 621. HEALTH HAZARD CONTROL FOR SPECIFIC EQUIPMENT
AND OPERATIONS FOR CONSTRUCTION
R 325.62102. Adoption and availability of standards.
Rule 62102. (1) The following federal Occupational Safety and Health Administration
(OSHA) regulations are adopted by reference in these rules:
(a) 29 CFR 1926.154 “Temporary heating devices,” as in effect as of the effective date
of these rules.
(b) 29 CFR 1926.300 “General requirements,” as amended March 7, 1996.
(c) 29 CFR 1926.302 “Power-operated hand tools,” as amended June 30, 1993.
(d) 29 CFR 1926.350 “Gas welding and cutting,” as amended June 30, 1993.
(e) 29 CFR 1926.353 “Ventilation and protection in welding, cutting, and heating,” as
amended June 30, 1993.
(f) 29 CFR 1926.354 “Welding, cutting, and heating in way of preservative coatings,” as
in effect as of the effective date of these rules.
(g) 29 CFR 1926.400 “Introduction,” as in effect as of the effective date of these rules.
(h) 29 CFR 1926.403 “General requirements,” as amended February 13, 1996.
(i) 29 CFR 1926.600 “Equipment,” as amended August 9, 2010.
(j) 29 CFR 1926.605 “Marine operations and equipment,” as amended July 22, 1977.
(k) 29 CFR 1926.850 “Preparatory operations,” as in effect as of the effective date of
these rules.
(l) 29 CFR 1926.910 “Inspection after blasting,” as in effect as of the effective date of
these rules.
(m) 29 CFR 1926.914 “Definitions applicable to this subpart,” as amended June 30,
1993.
(n) 29 CFR 1926.950 “General,” as amended October 5, 2015.
(2) A reference to 29 CFR part 1926 subpart D “Occupational Health and
Environmental Controls,” means the following MIOSHA standards:
(a) Construction Safety Standard Part 1. “General Rules.”
(b) Construction Safety Standard Part 42. “Hazard Communication.”
(c) Occupational Health Standard Part 601. “Air Contaminants for Construction.”
Page 1